MR-PMC電位器變送器Potentiometer converter

MR-PMC電位器變送器Potentiometer converter (1ch)

This is a converter used for converting to DC signal
by using input source of a potentiometer.
With built-in noise removal filter, transfers correct
signal, and precision isolation circuits enable
perfect signal transfer not affected by withstand
insulation voltage, transfer speed, noise, etc.

FEATURES
Small size(mm) : 83(H), 51(W), 102(D).
Isolation : input to output to power supply.
Power supply : AC or DC supply.
Wiring : terminal socket wiring.
Case & color : black ABS plastic case.
Weight : about 400g
MR - PMC
INPUT SIGNAL SPECIFICATION
OUTPUT SIGNAL SPECIFICATION
Output voltage signal : 12VDC max.
Output voltage impedance : 2Kohm min.
Output voltage noise : 10mV p-p max.
Output current signal : 30mADC max.
Output load resistance : 750ohm max.
Output current noise(250ohm load) : 10mV p-p.
GENERAL SPECIFICATION'S
Operating ambient temperature : 0 - 50'C.
Non operating ambient temperature : -20 ~ 80'C.
Temperature coefficient : 0.015%/'C.
Operating ambient humidity : 90% RH max.(non condensing)
Insulation resistance : greater than 100Mohm with 500VDC.
Dielectric strength : 1500VAC @ 1minute (input to output to power).
Adjustment range : 20% (zero & span) min.
Conversion accuracy : 0.2% max.
Response time : 0 - 90%(0.5sec).
Burnout circuit : upscale(standard).
OUTPUT IMPEDANCE OUTPUT LOAD - R
0 - 1VDC
0 - 5VDC
1 - 5VDC
0 - 10VDC
0 - 1mA
0 - 20mA
1 - 5mA
4 - 20mA
> 1Kohm
> 2Kohm
> 2Kohm
> 4Kohm
< 15Kohm
< 750ohm
< 3Kohm
< 750ohm
Input type : 2wire or 3wire.
Input signal : potentiometer(volume).
Input range : 100ohm - 2Mohm.
EXT Power : 5VDC
This is a converter used for converting to DC signal
by using input source of a potentiometer.
With built-in noise removal filter, transfers correct
signal, and precision isolation circuits enable
perfect signal transfer not affected by withstand
insulation voltage, transfer speed, noise, etc.
DISPLAY (OPTION)
Type : 3 digit FND
Display font : red super bright
Display function's : input or output or percent(%).
Display error : 1digit(LSB).
DISPLAY SIGNAL
1 : Input signal
2 : Output signal
3 : Percent(%)